This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Official
Comments
I am using 6 of them at the moment with homey and this issue is inconvenient but not a showstopper for me.
Tested tonight.. the spin wheel keeps spinning when testing a flow. I manually cancelled the test after 45 mins.
Now i need to re-pair the device and it works for a couple of days.
Is it helpful if I post a screenshot of my settings?
I added extra z-wave node nearby as Homey was pretty far away but that didn't solve anything
It only works when I reset the knob.
I was considering adding another zwave device as well nearby, but based on #OGS that seems to not help either.
For now the LC-13 is useless.
Oh, and camera's are still not supported.
I don't get it. I linked this LC-13 to my Homey. It recognizes the Danfoss. So far so good. After a while I get the E5. This is no surprise since I've read that in this topic.
What I don't get is that I created a flow, telling the LC-13 that I want it a 21degrees celcius at 06:30h. However...checking the radiator at 07:00h, it was still cold!
The E5 shouldn't interfere right? So...why isn't the radiator warm at 07:00h?
To view (non)progress on the E5 error look here:
https://github.com/athombv/homey/issues/1187#issuecomment-269778089
Hope it stays that way
1.2. is only on experimental atm.
But I can confirm that the E5 seems to be gone.