This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Closed
Homey v0.9.1
This discussion has been closed.
Comments
Relais switch (2x1) give same.
have you tried to power cycle? (pull the power plug and insert it again)
pull the power plug of homey and re-insert it
- Z-Wave Fibaro Eye flow action is working again (finally i can pee again at night with the Hue light in the bathroom on 25% :-) )
- Adding Fibaro Z-Wave devices works as a charm, although must say that the Fibaro door sensor did not see the temperature sensor attached to it, have to investigate further
- KaKu stopped working after upgrade, removed app, rebooted and installed app, still not working. After removing power for a minute KaKu was working, succesfully added a remote (checked functionality with an Arduino and a receiver) just to be sure signals are sent
The temperature capability has not been added to the door sensor (yet) the same is for the smoke sensor.
So you will have to wait for athom to implement it as well.
for the power cycle, take off the power of homey for at least 10-15 seconds (more = better) but you don't need more then 30 seconds
How long did it take for the app to crash?
You could report your issue here https://github.com/athombv/com.fibaro/issues
And include the crash (hovering with your mouse over the red triangle)
I'm sure it'll all work out in the end of your patient enough.