This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
bass850
About
- Username
- bass850
- Joined
- Visits
- 13
- Last Active
- Roles
- Member
Comments
-
Hi All, I was offline a while due to workload but I got time to get back to trying to get Homey and Visonic Powermax+ working. After more hours trying all different options with hardware and even factory resetting the Homey a colleague of mine came…
-
konradwalsh said: are you sure you putty baud rate/speed is right? Hi Konrad. I don't set that in putty since i telnet to USR device. In the serial port settings in USR device it's set to 9600/N/8/1
-
Well I, checked connections for n-th time. I think RX/TX are connected according to what's set forth above. I also changed power on USR from 3.3 to 5 volts pins (and on power supply too) but i keep getting same results: When i press Install Plink…
-
bass850 said: RemcoHannink said: @bass850 I connected a USR-TCP232 module to the serial pins of my Powermax+ according to the following diagram: | | | [0] [1] [2] [3] [4] [5] [6] | | [7] [8] [9] [A] [B] [C] [D] | | | | | |_______…
-
RemcoHannink said: @bass850 I connected a USR-TCP232 module to the serial pins of my Powermax+ according to the following diagram: | | | [0] [1] [2] [3] [4] [5] [6] | | [7] [8] [9] [A] [B] [C] [D] | | | | | |______________________________…
-
bass850 said: RamonBaas said: @bass850 Looks like you've connected the wires to 10, 12 & 14 instead of 1, 3 & 5. Really. I checked it against many sites. But if you say so. I will reconnect and test again. Thanks for you…
-
RamonBaas said: @bass850 Looks like you've connected the wires to 10, 12 & 14 instead of 1, 3 & 5. Really. I checked it against many sites. But if you say so. I will reconnect and test again. Thanks for your quick reply!
-
PPS In putty it shows the below when I press install powerlink in pm+ menu so it does seem to have some sort of connection...
-
PS I don't see the 14 bits in the web interface of the USR as described by luccie_007 in his above post: i assume it should be in last line of this screen?
-
First of all many thanks to Ramon for building this plugin. I am trying to set his up with Powermax+ and USR-TCP32-T2. I am using: - Powermax plus (12 pin) - USR-TCP232-T2 (connected to pins 1,3,5 as specified in above post by luccie_007) - Extern…