Hello,In case of two load You can use Relay Switch – but it must by powered.
If You want to use dimmer You can use second scheme from Your email.Regards
I had also troubles but managed to add it after full factory reset (2 times)
As far as I know you can only attach one light to the Fibaro Dimmer 2. This light is then switched by the S1 input. If you attach a second switch to the S2 input of the Fibaro dimmer you can link specific actions to that switch (different actions for e.g. one/double/triple/long press).
Thanks for your help.I
think I will try to make it as simple as possible: I just want to
control one of the two lamps (the one that is dimmable), I would like
you to tell me which of the two schemes is the right one.Thanks!
@pelaoboyka See page 9: https://manuals.fibaro.com/content/manuals/en/FGD-212/FGD-212-EN-T-v1.3.pdf