›
This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.
Closed

How to disable experimental updates

LinuZZLinuZZ Member
in Archive
Hi, 

some time ago i decided it would be fun to enable experimental updates on my homey and although it has not caused me any problem yet, i would like to switch back to stable but the checkbox is grey and checked. how can i disable experimental updates (i do accept to not be able to downgrade to stable, i just do not want to continue upgrading to experimental)

hope someone can help

Comments

  • GeurtDijkerGeurtDijker Member
    edited October 2016
    By design you can't switch back.
    But last time I reset homey back to defaults it was disabled 
    https://www.athom.com/en/support/KB000026/
    I guess you still can restore the configuration during the reset.
  • DieterKoblenzDieterKoblenz Member
    else, if you do not want to reset just disable automatic update and only update when firmware hits stable.
  • LinuZZLinuZZ Member
    i tried turning homey upside down and reconnected to my wifi but it still is on experimental updates. i do not want to remove all things configured just to change back to regular updates. can the checkmark be made available so i can uncheck it?
  • DennisBlotenburgDennisBlotenburg Member
    You can't! I refer to Emile's update status of november 1st: https://forum.athom.com/discussion/1430/software-status#latest 

    He says it will be possible with firmware Homey v0.11.0 that's version is not (yet) published. 
  • RocodamelsheRocodamelshe Member
    edited November 2016
     firmware Homey v0.11.0 that's version is not (yet) published. 
    And not going to be published.
    1.0.0 will be the next update.
    There will also be an option to go back to regular FW.

  • EmileEmile Administrator, Athom
    An extensive support article will be published next week, but for now: hold [ALT] when you're on the 'Checking for updates' screen at setup.athom.com, and select 'Revert to stable channel'.

  • LinuZZLinuZZ Member
    edited November 2016
    asked support
  • PimViergeverPimViergever Member
    Will this still be an option in the near future?
  • BramBram Member
    More information about how to disable experimental updates can be found here: https://www.athom.com/en/support/KB000041/
  • BramBram Member

    ModBreak:
    This post / discussion is deprecated and therefore closed.
    Please search the forum for a recent discusstion. 
    For questions or if someone disagrees, please contact me or one of the Community moderators

This discussion has been closed.