Fibaro plug not responding

Leeuw1960 · August 2018

i have got a fibaro plug that is no longer responding.
when i look in the developer tool i see the flag says " NoAck, Secure "
and When i press heal i get the error " REQUEST_NEIGHBOR_UPDATE_FAILED"

what can i do to fix it.

Image: https://forum.athom.com/uploads/editor/e1/rzrfu5k8z63o.png

phil_s · August 2018

take the pug and plug it near to homey and wait if it wll respond again.
then you know that it was to far from homey placed and you have to take another plug to make a bigger zwave mesh and reach more devices

Leeuw1960 · August 2018

phil_s said:

take the pug and plug it near to homey and wait if it wll respond again.
then you know that it was to far from homey placed and you have to take another plug to make a bigger zwave mesh and reach more devices

it was already near several other plugs and the distance to homey was plusminus 2 meter without walls.
i placed the plug on 0,5m but sadly no difference

rickp · August 2018

Sounds like;

https://forum.athom.com/discussion/5318/problem-removing-z-wave-device#latest

Leeuw1960 · August 2018

rickp said:

Sounds like;

https://forum.athom.com/discussion/5318/problem-removing-z-wave-device#latest

i think i have no problem with removing te plug and reading te plug but then i must check my flows en ad the new plug.
and that not what i want.
I want the plug to lissen to me and switch on or off when i tell it to do

Rocodamelshe · August 2018

And what if the plug died?

Best way to find out is to remove it from Homey and re-add it.

Leeuw1960 · August 2018

Rocodamelshe said:

And what if the plug died?
Best way to find out is to remove it from Homey and re-add it.

I removed it en readdited it and than it works. Sadley you must change the flows ?

Fibaro plug not responding

Comments