This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Closed Official
Homey v1.5.X - Stable
This discussion has been closed.
Comments
Command[1965] end: sendData
[2017-09-15T07:36:08.293Z] ProcessSendData[1965]: Error: TRANSMIT_COMPLETE_NO_ACK
[2017-09-15T07:36:08.295Z] ProcessSendData[1964]: To node: 77 with data: 0x988089747ad64df078b6 and txOptions: ACK,AUTO_ROUTE
[2017-09-15T07:36:08.298Z] Command[1964] end: sendData
node 77 is a fibaro motion sensor zwave plus
It basically just appears to stop responding, but the Fibaro door sensor in the same location works fine.
Usually, manually turning the device off and on, or unplugging it and plugging it back in fixes the problem.
But 95% of the time, I just give Homey a reboot and it starts working again.
thanks for your comment. Unfortunately my problems are really due to a congested zwave queue. Once the queue is empty the switch works perfectly.
What do you mean as a basic device? Would it still function?
Also what I forgot to mention, after waiting long when pressing delete a device, it says (in Dutch) didn't found a device to delete, make sure the device is turned on and available.
https://github.com/athombv/homey/issues
What I have learned is add permanent powered devices first while keeping your homey at its base location. Then add the battery devices to homey from the location where you going to put them. This can take a couple of times before it succeeds as the devices often need to communicate via the permanent powered devices. My mistake was adding all battery devices next to homey and then move them to the other side of the house, the mesh routing table isn't correct anymore and things start to fail. Thanks for the support.
That is not possible... To include a mains powered z-wave device, I have to have Homey within 1 meter distance... So, it can't stay in Iets base location.
But then you are saying you are moving the homey through your house? Or do you add all the main powered devices next to homey's base location?
https://forum.athom.com/discussion/3581/optimal-sequence-for-including-components
powerbank works perfectly indeed!
@elwin23
Added three GU10 Tradfri yesterday (one by one ;-) ) but at least two didn't add the first time, I think I have seen the Device already exist two times (maybe 3). But opening the Add Wizard again and doing direct a Power off - 2 seconds wait - PowerOn Added them.