This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Closed
Homey v0.9.2
This discussion has been closed.
Comments
Could the post of Emile be of any help?
Where it could see all the devices before (not working correctly but that is something else) now it does not see them or, I can't find the button to update the network
However, trying to exclude Homey from the network was not possible: the buttons for excluding remain greyed out after the first try but Homey can not be used as primary/separate controller anymore. Is factory reset the only way to recover?
Homey now can control my KAKU/NEXA sockets! Pairing goes generally well, but range is poor (4-5m without wall on sensors/remote).
-KAKU remote won't respond in flows anymore, even right after pairing successfully 1m from Homey, which I find odd. PTP doesn't seem to fix this either. (Testing the flow with the test button works fine obviously)
-Doorbell pairs fine when generating a new signal, but homey does not register the "copy remote" from the remote. PTP will sometimes help pairing the remote (first step), but then the doorbell won't respond to the test signal (2nd step)
No hiccups with my 7 hue lights or Chromecast so far
FYI: I've unplug the Homey for more than 8 hours and paired the sockets again.
for example i cleared the memory in my case the acd-200,in the beginning i had paired them with the remote control
so maybe it is a memory problem,you can always try
Kaku works (ACDB-7000, APIR-2150 and new in 0.9.2 is that ACD-3500 also works)
still have to try and reconnect my AFR-060 that stopped working
Smartwares works (SH5-TSM-A)
LIFX works (as it has been working fine)
my zwave.me times out before connecting. Have to fiddle around with this.
I have a Zwave ME 05433. Cannot connect it to homey (it could be connected in 0.39): In the zwave pairing process, while the command classes are fetched, my 05433 times out, which causes terminating of the pairing process.
Moving homey next to my switch did not help.
Maybe it's just the everlux device but for now the rewrite of z-wave is not bringing much joy
With sometimes no data.
No movement.
No lux
No temp
And no battery andere no tamper
Battery empty within aan week
It is not working as it should be
Z-wave me app is not compatible with Everlux SKU: ZME_05433
Good news I have 1 out of 3 working after trying too many times but it's detected as basis zwave device so on and of are working but dimmer not
One problem down, just the ASR-ZW support as on/off and Fibaro dimmer not recognised