This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.
Closed

Unable To Force Remove Dead Z-Wave Device?

My MCO 1-Gang switch died. There is no power to it. So when I want to force remove it, I am unable to do it.

I am getting a response_timeout error. I am on 1.5.11. Any ideas? I saw this on GitHub issues, https://github.com/athombv/homey/issues/2333, just want to bring it over here to see anyone has the same issue.



Comments

  • The only correct way to report issues is on Github. As i can see u alr did that bij commenting on the issue. This is a community forum and the Athom peeps is not always reading along. Therefor it is of no use to post the issue overhere again. For the same reason am closing this topic. If u have any problems with that , plz read the welcome post again (especially number 10) before u contact @Bram .
This discussion has been closed.