Fibaro universal sensor FGBS-001

MVanHouts

Hello all,

I'am trying to add the Fibaro universal sensor FGBS-001 to homey but cannot get it to work.
It is a brand new one, I already sent one back because I thought it was broken. My homey firmware is 1.5.8 and running Fibaro

v1.5.17 app.

What I do to connect it to the homey:
Set 12 volt power to the red (+) and blue (gnd) wire, go to the homey app and add the sensor as a new device.
Homey says to press the b button 3 times but never sees the device. I also tried to remove a z-wave device but still homes sees nothing. I also tried pressing 3 times fast and slow and rebooting homey, but still no go. So i'am running out of options here.
I rather not reset my z-wave network because of the 12 working z-wave devices that I have to get reconnected if I do that : - (

Maybe somebody has a good tip on how to get it done?

Tnx 

skoni

Vergeet deze sensor maar. Werkt niet of niet goed in homey. Is al verschillende keren gemeld maar is nog niks mee gebeurd.

Oy1974

skoni said:

Vergeet deze sensor maar. Werkt niet of niet goed in homey. Is al verschillende keren gemeld maar is nog niks mee gebeurd.

No problems with it. Working perfect over here

skoni

Oy1974 said:

skoni said:

Vergeet deze sensor maar. Werkt niet of niet goed in homey. Is al verschillende keren gemeld maar is nog niks mee gebeurd.

No problems with it. Working perfect over here

Lucky you <span></span>

youask

I got my sensor to pair with homey after pressing like 6-7 times.
The uni module is connected to my DSC alarm PGM #1 and #2 output for homey to know if the system is ARMED or in ALARM mode. The input showed open/closed the first day but now i don't even know it homey is connected to the module anymore

skoni

@youask. I had the same issues with the module. Now I use a Neo coolcam door switch for input to my Homey. That works good. I have the reed contact replace by a relay contact.