Welcome to the Athom Community Forum! This forum centers around the product Homey. Homey is built by Athom and has a mission to connect everything at home. Read more about the product on the official Homey website.

This is a place to share ideas, ask for help and discuss about Homey in general.

Please read Welcome to the forum to get started.
Ask your Homey-related questions in this category. You can also go to athom.com/support to get support from Athom.

Fibaro Dimmer 2: Brightness Level Correction

Hi all,

I'm finalizing my migration from Domoticz to Homey and I encounter a small issue.
In Homey, I'm unable to locate the Brightness Level Correction setting while it was available in Domoticz.
I need to be able to set this value because of the ripple control.

Is there a workaround to find all the Z-Wave controls?

Thanks,
Rick

Comments

  • casedacaseda Moderator
    edited December 2017
    Brightness level correction? Can you iterate a bit more, like a parameter number? As I can't remember of such an option in the parameters

    If it is the "minimum brightness" and "maximum brightness" settings, then they are in the device's settings.

    If you do know the parameter you can always use the expert parameter settings input.
  • Hi caseda,

    That should be parameter 38: "Brightness level correction for flickering loads".
    Tonight, the lights went to 100% brightness without any trigger because of this issue.
    Where can I find the expert parameter setting input?

    Thanks and a happy 2018!
    Rick
  • Fire69Fire69 Backer - Geek Edition
    Happy New Year :)

    Is it possible this is only available in newer firmwares?
    The pdf of the manual I saved some time ago (v1.0) doesn't have parameter 38.
    The new version from the site (v1.3, fw 3.5) does have it.
  • rw90rw90 Member
    Fire69 said:
    Happy New Year :)

    Is it possible this is only available in newer firmwares?
    The pdf of the manual I saved some time ago (v1.0) doesn't have parameter 38.
    The new version from the site (v1.3, fw 3.5) does have it.
    Yes, I believe it's part of a new FW.
    See p29 in the following document: https://manuals.fibaro.com/content/manuals/en/FGD-212/FGD-212-EN-T-v1.2.pdf
  • rw90rw90 Member
    edited January 1
    Just found the RAW config parameter field.
    Entered "38,2,125;", so I'm curious if it will fix the issue!

  • HomeyNVHomeyNV Member
    edited January 5
    And...... did it work out? I'm having the simalar problems that my lights spontaneous brightens. Sometimes it dims back and sometimes the ligths stay in the brightend possition. 
  • rw90rw90 Member
    Needed a few days to confirm, but so far so good!  :)
  • rw90rw90 Member
    Didn't had this issue since, so I finally confirm that the change worked!
Sign In or Register to comment.