MCO Home support

Mariuss · June 2017

Any plans to support MCO Home devices? Tried to add a PM2.5 sensor by using general z-wave device but no success.
Anyone been able to add this device to their setup?

lubbertkramer · June 2017

@Mariuss General z-wave devices can only be added with on/off capabilities, when you want to use devices with more capabilities there needs to be an app for it with those defined. Athom made the Fibaro but the community (@tedtolboom and @mruiter ) made the Neo for example

TedTolboom · June 2017

@Mariuss this happens to be on my list; expect to receive next week a MCO home thermostat (MH7), CO2 sensor and double switch...

So yes, I'll make an MCO home app and expect to be able to make a PM2.5 sensor driver based on experience with the CO2 sensor....

Mariuss · June 2017

Very nice @TedTolboom ;

looking forward to test this.
Used to have a Zipabox that was able to support this, MCO is the only thing missing in my move to Homey

TedTolboom · June 2017

@mariuss well if I can support to complete yet another transfer ;-P
You only have the MH10 PM2.5 sensor or more MCO home devices?

Mariuss · June 2017

Currently I only have the PM2.5 from MCO.

walter · July 2017

Ik hoop dat jullie deze ook kunnen toevoegen.
http://www.mcohome.com/show_list.php?id=13

Mooi en stijlvol. Op mijn vera en zipato geen problemen.

Mariuss · July 2017

How is it looking @TedTolboom? Got your devices yet?

TedTolboom · July 2017

@mariuss Yes, received them... hope to make some progress before the summer break... will follow up in: https://forum.athom.com/discussion/3463/

MCO Home support

Comments