Z-Wave compatibility

nikku

This may be a silly question, but I was curious if the onboard Z-wave controller will have support for US Z-wave frequencies in addition to EU, or would a different module need to be added? I'm assuming the former, but figured I'd ask

Also will Z-Wave locks be supported, such as the Yale locks?

Thanks and Kind Regards,
Nick B.

Emile

We ship the Z-Wave accordingly to your shipping address. And yes, we follow the Z-Wave spec, so they will be supported.

nikku

Great, thanks for the quick response!

DamianArmitage

I have this Yale lock and cannot get Homey to work with it.
http://www.yale.co.uk/en/yale/couk/productsdb/smart-locks/keyfree-connected-smart-lock/

It once 'interviewed' it and understood it was a lock, but said it wasn't 'secure'.  Since trying to connect it again, painfully removing and re-adding i cannot get it to know what type of device it is.  I also cannot figure out what Homey is capable of doing with it.

Not having the easiest time with my new Homey.

Taco

Homey does support Z-Wave security. Please try again with your device close to Homey. If you're still unable to finish the pair wizard successfully pease send us the log usung Settings -> System -> Send Log and past the code here.

DamianArmitage

Thanks Taco. I wasn't expecting to need to do so much testing of this but I will try to keep the faith...

Obviously I can't bring the mountain to Mohammad on this occasion so I'll have to move my Homey close to my doors.  I will try this tomorrow and feedback.

Reemster

Does anybody knows, if Fibaro fire/smoke sensors are working already with Homey? i try to add them, but with no success. The motion sensors of Fibaro are working, sometimes... not very stable  

Jaxc

Fibaro smoke sensor up and running no problems here. 

Reemster

JurgenHuijbregts said:

Fibaro smoke sensor up and running no problems here. 

that's weird.. when i finally succeeded to add them, i get after a few minutes later by - settings <--> zwave - all failed status, behind the fire alarm sensors.

Jaxc

I will post my settings tonight, maybe the is not working due to the settings.

Jaxc

Jaxc

These are my settings, and stable working. for about 5 days now...

kasteleman

No Z wave associaties.......

Reemster

JurgenHuijbregts said:

These are my settings, and stable working. for about 5 days now...

ok thanks  i shall try your settings

Reemster

It's not possible to get Fibaro fire sensors working. I can add them, (with difficulty) but when they add, there is no data. or is that normal for now, and that homey don't support that yet? i don't see the battery percentage, not the temperature. 

Jaxc

You can see the temperature and bat level in ínzichten' (dutch) after a couple of minutes

Reemster

JurgenHuijbregts said:

You can see the temperature and bat level in ínzichten' (dutch) after a couple of minutes

ok, i didn't check that. thanks

chrisnash

DamianArmitage said:

Thanks Taco. I wasn't expecting to need to do so much testing of this but I will try to keep the faith...

Obviously I can't bring the mountain to Mohammad on this occasion so I'll have to move my Homey close to my doors.  I will try this tomorrow and feedback.

@DamianArmitage ;did you ever get your Yale lock to connect?

kasteleman

Anybody using qubino devices? Building a app for my 2 devices (qubino flush dimmer 0-10v and flush dimmer non z-wave plus)