This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
0.8.30
![aloft](https://secure.gravatar.com/avatar/ef0b602fedce5f257192d638345d3a91/?default=https%3A%2F%2Fvanillicon.com%2Fef0b602fedce5f257192d638345d3a91_50.png&rating=g&size=50)
Release notes:
0.8.30 experimental
- Upgrade to NodeJS 4.4.7
- [Z-Wave] Homey now reaches out to unreachable devices.
- [Z-Wave] Humidity capability now added correctly.
- Fixed a bug where holding your Homey upside down during an update could brick Homey
- Fixed a bug where setting your speaker volume would fail
- Performance improvements
- Improved Dutch support
Comments
Check out the low load average, even when the CPU is dynamically downclocked to 396 MHz. Credits to @JeroenVollenbrock for the optimizations!
- Z-wave pairing: some devices pair instantly, one devices (so far) crashes in the interview stage ( where they paired withouth issue in 0.8.29 . Z-wave chip needs to be restarted afterwards. Log ID 1BDD13EE66 @Taco ;
- CPU load much lower, great!
However, still unable to correctly add my FloodSensor.
NooP
If so, what I had to do was to enable the automatic updates, go to another section in Settings, go back to Updates, and uncheck the automatic updates. Then it showed me the available update.
I deleted and reionstalled KaKU but no go?
Any news on this?
using kaku 1.1.1
Firrmware 0.8.30
but after reboot of homey all OK again
Edit: reinstalled BetterLogic and recreated a couple of flows. Variables haven't disappeared since the reinstall.
updating now
thnx!
Cant seem to get logitech installed??