This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
vidjense
About
- Username
- vidjense
- Joined
- Visits
- 69
- Last Active
- Roles
- Member
Comments
-
Never done Perhaps less mess and smell with spray!?
-
After communicating with support at Popp, they could reveal that you cannot trigger a smoke alarm with the test button in the zwave network. You have to trigger a real alarm for this. Also the association group 2 (alarm) will not be triggered by oth…
-
I tried that, no difference. Regarding the "grey out". The NodOn Smart Plug is the same. It is only black if the light is turned on. Light OFF: Light ON: Smoke alarm sounding (used the "Turned on"-switch to sound the alarm):
-
The mobile card in the "Zones & Devices" does not indicate that the alarm is sounding. I can turn on and off the alarm with the switch on the card, but it does not indicate alarm when I push the test button.
-
Regarding the test button. Here is what I found in the manual: "A button on the device can be used to test the smokebox, the electronics and the battery. In addition the device has an integrated test functionality to make manual tests with Aerosol …
-
In the zwave log I find 2 entries, after pressing the test button, that may be what you are asking for: Decapsulated frame from COMMAND_CLASS_SECURITY to COMMAND_CLASS_SENSOR_BINARY, data 0x03ff02 and Decapsulated frame from COMMAND_CLASS_SECURITY …
-
Well, after some detective work, I followed the "Getting Started" and installed the NodeJS, added the Node.js pack in VS Code, downloaded the project from Github, changed the "debug:false" to true in driver for the 4001 and run the project with "ath…