This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
jorgensen
About
- Username
- jorgensen
- Joined
- Visits
- 9
- Last Active
- Roles
- Member
Comments
-
An update on this one. It kind of worked :-) After changing the mode to on/off the light did not switch off when motion was detected. However, it turned off after 10 minutes - I guess when the sensor sent a signal that no motion had been detected …
-
Alright, thanks. The switch seem to have three modes. 1. Momentary 2. Toggle switch (Closed = on, Open = off) 3. Toggle Switch (Change states) Right now it is set to 3. I will try and set it to 2. and see how that goes tonight :-)
-
From Homey I send an "on" - I dont know what kind of signal the old motion sensor is sending. I guess it just "toggles" but since it is no Z-wave device I cannot change that. So I was wondering if I could change something on the switch.