This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Vagabond
About
- Username
- Vagabond
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Does not help. I tried to access incognito and normal. Cleaned the browser cache and tried again. Nothing is changing.
-
I guess something went wrong for me. After installing the update, I cannot access anymore "Devices", "Flow" and "Setting" via browser. "Insights" works fine. It seems to be a display issue since my devices are still there and my Flows still work fin…
-
How do you managed not to have the secure option? I tried to pair it several times, but always secure and not choice to untick it during pairing. Nevertheless it seems to work better. I see now tamper, motion, lux and temperature alarm immedietly. T…
-
What I miss with my Donfoss is the option to say "switch thermostat on" and "switch thermostat off". In principle I want a flow which sets the room temperatur to 22° during day and 18° during night (measured with the Fibaro) My problem is that the …
-
Thanks. What would be the advise to use the Temperatur measurment of the Fibaro Motion Sensor to controll the Temperatur target?
-
I would like to use a Fibaro Sensor to controll my Danfoss thermostats. I just tried to set up a flow but just could find for the Sensor "When the temperatur is changed" to trigger an action. What I want to do is that my Danfoss heating till the Fib…
-
It seems the problem is that it is (at least not for me) not possible to check or unchecked the secure tick. Tried to switch to non secure mode by putting parameter 18 = 0. Generall it seems that additinal parameters are not communicated from Homey…
-
Thats actually a very good hint. I was looking though the manual and havent found anything how to deactivate the secure setting by pushing the B-Button. Could you please help? P.S. Yes... I am new to z-wave.
-
caseda said: Can someone Confirm my assumptions?: It looks like v3.2 has thrown around with the Association Groups compared to 2.5 - 2.8 (stated as 2.7 from now on): 3.2 Group 1 = 2.7 Group 3 3.2 Group 2 (Motion Z-Wave+) & 3 (Tamper Z-W…
-
With V3.2. caseda said: This should work for all Versions, not tested with the new Z-Wave Plus though: Make sure your to be added Motion Sensor is properly Reset, Even after you deleted it in homey: Hold B-Button until Yellow LED light turns…
-
It seems I am also doing something wrong since I can also not uncheck the secure tick. What I am doing wrong?
-
I am struggling now with the correct settings of teh Sensor. Which ones I have to use for V3.2? Thank you.
-
Okay, worked now to pair. I had to do a reset of the sensor.
-
Thanks, done. But now Homey cannot find the Sensor as new device when putting to the Sensor to learn mode.
-
I received my Homey a couple of days ago and starting to set up my zWave Network. Howevery I also have problems to pair my Homey with the Sensor V3.2. I put the Sensor right beside of Homey and start pairing. Device was found, but during the Intervi…