This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
quart
About
- Username
- quart
- Joined
- Visits
- 21
- Last Active
- Roles
- Unconfirmed, Member
Comments
-
I use: Plugwise Source Beta v2.0.3 Dont put any time into this. I will test with another flow first
-
Now I have installed the beta and it works great with Stealth units !
-
Thank you so much !! Did you also check why the circlees just toggle on/off each time. But thaty I mean that when sendning two off signals after each other the cirlce turns on. I have a flow that checks light levels each 10 minutes, and below a val…
-
Looking great, keep up the good job
-
Thanks again. I sent you a PM with the statistics.xml
-
Nattelip said: i dont have stealths if you give me the xml of the stealths ? Thanks for quick answer. Its been a couple of years since installed and configurred Plugwise. Can you explain how I can get the XML file for a Stealth applica…
-
I think I solved it. I moved the multisensor inside my house so it got better tx/rx and after that the Fibaro motion sensor connected to the Multisensor. Now I put the Fibaro motion sensor outside, hopefully my z-wave network is stong enough now.
-
I have problem with this multisensor not being in "mesh" mode. I have it running with the usb cable and have paired it. i have a Fibaro motions sensor that is outside that I was hoping that could connect throw the Mutlsensor. But it doesnt. It also …
-
I have a couple of steatlh devices.. Is there anyway to get in to Homey aswell? I can se them in the Plugwise source webpage