This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Dmitry1980
About
- Username
- Dmitry1980
- Joined
- Visits
- 22
- Last Active
- Roles
- Member
Comments
-
I found the instruction, about 4 groups in general, not a word, tried to reconnect it with the model of ZMNHD, it does not work, it still indicates my model. https://www.benext.eu/static/manual/qubino/flush-2-relays-ZMNHBA2.pdf
-
kasteleman said: hmmmm, what about the association configuration?
-
kasteleman said: Had to ask, because it wasn’t that obvious for everyone. Can you give the model type you are using? ZMNHBA2
-
kasteleman said: Do you have a temperature sensor attached to it? Yes of course
-
Good afternoon everyone! Can not figure out the temperature sensor? gives a temperature of 209 degrees.