This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Grisen
About
- Username
- Grisen
- Joined
- Visits
- 57
- Last Active
- Roles
- Member
Comments
-
mruiter said: @Grisen If youre V1 has already the sensor but not the V2 firmware there isnt much i can do. It will give a error on all the other V1's with the correct firmware. If you have a correct V2 with a V2 firmware and a temp sensor it w…
-
@mruiter I tried to pair the same pir with my friends Fibaro HC2, and there the controller managed to pick up motion, lux and temperature. Am I doing something wrong when I pair my device to Homey, or is there a limitation in the neo coolcam app?…
-
I am trying to cast the Swedish radio station P1 using the "Cast Radio Station" card. I only get the "Load failed" msg, other stations work fine. Is it possible to edit the link? There are quite a few different urls available http://sverigesradio.se…
-
Read the post above about PIRs that actually do not contain a temperature sensor even though they are marketed as such. I have recently bought two PIRs from the Coolcam store and they claim it should include a temp sensor. I have tried removing and …
-
Tried the 4 push in 5 sec and the press and hold for 10 sec. Not sure which thing that did the trick but after that I was able to add it again. Thanks guys
-
bvdbos said: The issue is the device is gone in "devices" but it's still there in the charts. Ran into that in the past: https://github.com/athombv/homey/issues/1718 This was possible by choosing "delete" in the charts but since they charts mov…