This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Solved
[Solved] Not single qubino ZMNHDD1 will work
all my qubino ZMNHDD1's won't work. I can add them, but once i have, the dim slider stays gray and there is no power or power meter info. And when I remove & add them again: same result.
Which is unfortunate, because I had six of them already, so they have cost me more than my new homey..
In Domticz, they worked just fine.
Which is unfortunate, because I had six of them already, so they have cost me more than my new homey..
In Domticz, they worked just fine.
Tagged:
Comments
the slider is gray when the device is switched OFF, click on the device-icon to switch it on.
Yes, I did install the qubino app.
and if i click on the device it does turn black instead of gray. But the lamps on the dimmer just stay on and won’t turn off or dim. Also, there is no power and power meter readout. The symbols are there, but there is no value.
I have removed and added two of my dimmers multiple times, but every time, they just won’t react.
maybe i should remove and install the qubino app?
But When removing and pairing,, I put the homey to within one meter as the qubino manual says. (Pairing and removing doesn’t work if you don’t)
When I look at the zwave mesh at “stuff for geeks” in zwave menu, the dimmers are there and connected to most other devices, and homey.
They just won’t react.
Qubino relay modules do work, by the way.
Do the dimmers switch ON/OFF by connected switches/push-button ( I1 connection)?
Maybe a module reset is needed, to reset all parameters to default:
Press push-button I1 five times within 3s ( 5 times change switch state within 3 seconds) in the first 60 seconds after the module is connected to the power supply.
By this function, all parameters of the module are set to default values and own ID is deleted.
But: Hallelujah!
I got one to work in a here goes nothing for the oemphteenth time effort:
While adding the module, homey was getting parameters and then it said that it lost connection and I needed to put homey closer to the module. Not in those exact words, but you get the idea.
So I moved it as close as possible, 10 centimeters or so, and now it finally works.
It will be uncomfortable this way with the next 5, but I'm confident it's gonna be ok.
I hope this will help others having the same trouble.
Any help would be appreciated!