This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Comments
If not then its correct its added as unknown z-wave device
I have been working on this, but not sure if I got the settings right yet. If you want you can test it. It works for me regarding detecting if it is open/closed, but not sure about battery readings and as I mentioned the settings. New to Homey apps.
To test it you would need to download and install the project onto you Homey.
https://github.com/yhaugom/com.telldus
If you didn't try it before, have a look here:
https://developer.athom.com/docs/apps/tutorial-Getting%20Started.html
Skip step 4, just run or install my telldus app by following the instructions.
I have started submission process to the app store as a beta application as well. Waiting for approval. If it is approved you could just install it like other apps.
Maybe you can do that already?
Here is the link: https://apps.athom.com/app/com.telldus
Did some testing last night, and I can add the door sensor and it works as long as i have it on my desk but when I move it to the Door where it should be it get out of range even if its less then 5m and I have a Fibaro motion sensor less then 2m from the doors sensor.
Then after it get out of range it stops working even if I get it back to my desk.
And then when I try to remove it. It looks like its ok but when i look at the Z-Wave map it still there and I can see it in the Devices. So to get it out I have to reset my Z-Wave net and start all over again.
I havnt change any settings so no testing of that.
If I look at the settings I can only see Association group 2 and 3 cant see 1.
The sensor added easy that was good
So hope the rest can be fixed, greate work looks good.
Works from another floor for me. Got two sensors working good.
I don't think group one has settings? Or am I wrong?
Thank you by the way! :-)
Link to Telldus
It's not needed to use the plug, however there are some pros to having the correct app for it (correct icon, can select device class during inclusion).