Rolling Code Garage Door/Opener 433MHz + Homey

Comments

• Priknr1 Member

  July 2017

  HI, welcome here.
  
  I cant answer your question for sure, But My guess would be 433Mhz rolling code, in Homey would be a pain in the ass.
  I would surely advise you to buy a Homey, It is fun, and handy, and ever growing to become better and bigger.
  
  When it comes to saving money by not buying remotes....
  In China (aliexpress or so) there are 433Mhz rolling code transmitters and recievers for just a few bucks.
  I connected a receiver to my garage door push button, and have 4 roling code remotes connected to this receiver.
  Total costs: €12,- or so. Works like a charm
  
  
• westd05 Member

  July 2017

  You can already control it with Homey if you install a Fibaro z-wave relais switch on you garage opener button. Almost all (if not all) garage openers have the ability to connect a button to open the door from inside the garage. Take the wires from that button and connect it to the z-wave relais switch.
  Make a flow where the relais switches to on for 2 seconds.
  
  Will it save you on remotes? Yes, if you needed more than one. You only need one zwave switch and everybody with a phone can have the right to open it.
• bvb Member

  July 2017

  I use a Qubion relais switch and a Vision Garage door sensor to control the status of the garage door. Over a virtual switch i can control the door over the app and with a z-wave.me switch I control it over the switch. With a flow home says "open" or "close the garage door" to get a response from the action.