This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.
Closed

wall switch Nodon and Remotec Scene Master

Hi all,


I was just wondering someone using the http://www.domoticawerkt.nl/nodon-wall-switch.html




And/or the http://www.hashop.nl/Remotec-Scene-Master-ZRC90


Im hoping someone off the  members willing to write app for both or even athom itself would be. Because some time its just better to have real switches other then using your Phone.


Thks

Comments

  • @Oy1974 ;
    Both use the central_scene command class, so they should be able to work if someone writes a driver for it. You could take a look at the fibaro swipe, wich uses the same "technique". (You maybe can reproduce)

    The thing with z-wave is you need to test it, without the actuall device its hard to write a driver for it.


  • swttt said:
    @Oy1974 ;
    Both use the central_scene command class, so they should be able to work if someone writes a driver for it. You could take a look at the fibaro swipe, wich uses the same "technique". (You maybe can reproduce)

    The thing with z-wave is you need to test it, without the actuall device its hard to write a driver for it.



    I understand, must say i dont have the skills to write or even reproduce something. Thats also the reasson that i wait till homey is in a consumer state. At the moment just being trying to find out what i want and what i wish, so there for was my question.


    Thks for your reply and maybe when i got finnaly a homey, there will be a app already written for it.
  • Currently, I'm writing an app for the Devolo wall switch. I think (with some small modifications) it can be used for these switches as well. 
  • hi, i'm new to this, but I sure would like some support for the ZRC-90 Remotec Scenemaster. Any progress since august?
  • actually I used the default Homey Z-wave install and now it appears to be installed somewhere because when I want to install it again Homey replies: "already installed". However the device doesn't show up in the devicelist. So I don't know how to remove it.
  • Ok, I found how to remove the Remotec Scenemaster. Since it wasn't recognized or functioning it wasn't much use. So now I'm waiting and hoping for someone to make it into an genuinely supported device.
  • I am using the nodon wall switch but it's too slow with responding and a the first button press is mostly not recognized.

    It takes more than 3 sec to turn on the lights (fibaro dimmer 2)
This discussion has been closed.