This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Using Fibaro Relais and Door Sensor to control Garage Gate.
viktor
Member
Hi all, im searching for Ideas how to make my flows to control my Garage Door. Already installed one FGS212 and Door Sensor. The Switch (both Homey and physical) are working and the Door Sensor is on when Door is closed, off when open. Now i made couple Flows to write the Door Status into BL Variable when opening/closing.
But i'm not sure if the Logic of the Flows is ok. I think when i go to use this flows i'm ending into loop and don't want to try it yet :-)
Do you have suggestions or ideas, or maybe a working instal?
Tnx
Viktor
But i'm not sure if the Logic of the Flows is ok. I think when i go to use this flows i'm ending into loop and don't want to try it yet :-)
Do you have suggestions or ideas, or maybe a working instal?
Tnx
Viktor
Comments
Better use "When variable has changed"
Just place it in the AND column to check what the current state it.
I'm note sure if it will work for you though.
My Garage Door is accepting only Impulse and conected like this: http://www.vesternet.com/resources/application-notes/apnt-124
I use Fibaro Door Sensor to recognise the State.