Using Fibaro Relais and Door Sensor to control Garage Gate.

viktor

Hi all, im searching for Ideas how to make my flows to control my Garage Door. Already installed one FGS212 and Door Sensor. The Switch (both Homey and physical) are working and the Door Sensor is on when Door is closed, off when open. Now i made couple Flows to write the Door Status into BL Variable when opening/closing. 

But i'm not sure if the Logic of the Flows is ok. I think when i go to use this flows i'm ending into loop and don't want to try it yet :-)

Do you have suggestions or ideas, or maybe a working instal?

Tnx
Viktor

Rocodamelshe

Did see that ur using "when variable is set "
Better use "When variable has changed"

viktor

Tnx, going to try now...

JaapPelt

The Fibaro rollershutter switch "knows" if it is up or down if you have your physical switch connected to it.
Just place it in the AND column to check what the current state it. 




I'm note sure if it will work for you though.

viktor

Hi @JaapPelt ;
My Garage Door is accepting only Impulse and conected like this: http://www.vesternet.com/resources/application-notes/apnt-124

I use Fibaro Door Sensor to recognise the State.

JaapPelt

viktor said:

Hi @JaapPelt ;
My Garage Door is accepting only Impulse and conected like this: http://www.vesternet.com/resources/application-notes/apnt-124

I use Fibaro Door Sensor to recognise the State.

That's unfortunate. Hopefully the suggestion is useful for some other users. It took me several months before someone pointed this option out to me