This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Closed
Fibaro Door / Windows Sensor FGK-10x
Hi, i'm trying to setup a fibaro door/window sensor but so far its not really working. Adding the device as a sensor works, but the alarms dont really measure up/work.
Can someone share his default settings with me?
I tried report to association group: 3 and 1, with 1 it the alarm stays on. with 3 the alarm stays off.
- I tried adding the devide as a sensor (think this is the right category right?
- when I try to set any Z-Wave Associations in the device config it gives: Cannot read property 'id' of undefined
- the interval is default set to: 16777215. If i try and change it gives the same error as above.
I looked in the manual of the sensor for additional info but couldnt find any values.
This discussion has been closed.
Comments
otherwise you will have to wait for the first wakeup interval
After that homey should receive the start and stop frames from the sensor (also: the alarm state).
Just a small side question: what Firmware version do you have of the sensor.
Default wake up should be: 4000 seconds / 66 minutes, and thus not the maximum of: 16777214 seconds / 4660 minutes / ~3 days.
The older version (2.1-2.3) does not specify the default in the manual, maybe that is why the maximum was chosen.
And it should be included with association group 3.
luckily i'm not the one creating the app, man that work.
but i guess that means it works now?
then @mranderson can do the same.
my door sensor is still (v0.8.35) added as a default device since the interview is not finished (issue 448)