This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Cycle times and handling of flows
I have a question about the cycle times and handling. I noticed sometimes when things get a bit complicated Trigger -> variable -> trigger on variable change -> turn on/off kaku device that it seems a bit slow.
When I look at this movie from an other topic
I see long delays between the different lights going on and of. Is this something to expect? Is this something to be fixed? Today I will make a debug tool to capture variables to test this a little further.
When I look at this movie from an other topic
I see long delays between the different lights going on and of. Is this something to expect? Is this something to be fixed? Today I will make a debug tool to capture variables to test this a little further.
Comments
They seem to receive the "turn on signal" one by one... Which sounds logical to me because they are not really on the same network and receive the on signal instantly at the same time.
We've also tested with 2 lights connected to Z-Wave sockets and they responded instantly. Switching both on in the blink of an eye.
@wvanderspek used 433mhz before with Domoticz and the behavior was the same, so I think it's a 433mhz thing...