Welcome to the Athom Community Forum! This is a place to share ideas, ask for help and discuss about Homey in general.

Please read Welcome to the forum to get started.

Problem while trying to connect my Nuki lock.

Hello,

I am receiving the error below while I am trying to connect my Nuki to Homey

Error code sendcommand: 403
You may close this window

Any help?





Comments

  • Hi,
    I don't yet own a homey or nuki, but from the nuki api 403 error is :
    • HTTP 403 Returned if the authentication is disabled
    • If discovery is disabled via /configAuth or through the Nuki App, the IP is 0.0.0.0 and the port 0. In this case the /auth command fails with HTTP error 403.
    here is the link to the nuki bridge api: https://nuki.io/wp-content/uploads/2016/04/20170619-Bridge-API-v1.6.pdf
  • jordenjorden Member
    This token is not correct.

    I will soon release a new version of the Nuki app. For now, you need to figure out your Nuki IP, then open in a browser window:

    http://<nuki IP>:8080/auth

    Within 30 seconds, press the button on your Nuki to allow the request.

    Then you will see this output in the browser:
    { "token": “token123”, "success": true }

    Copy the token (token123 in this case) into the app window in Homey.


  • Hello. 

    Thanks for the great support and now is all ok works fine, so the issue was that I didn't know that there are two API connections one for WEB API and one at the DEVICE Itself.

    Now all is ok works fine.

    Thanks,

  • jordenjorden Member
    Yeah two API's indeed. The app still uses the "old" API, because there wasn't  a web API yet when I started developing. Now there is, and soon I will make use of that instead.
  • jorden said:
    Yeah two API's indeed. The app still uses the "old" API, because there wasn't  a web API yet when I started developing. Now there is, and soon I will make use of that instead.
    Perfect thanks for the great support.
Sign In or Register to comment.