[1.5.3] Z-wave not working

FB2906

After the upgrade from last night 24 feb. the Z-wave network is no longer working accordingly. Fibaro products are no longer responding. and after a re-start Homey doesn't even recognize the learning mode etc from fibaro products anymore. Does anyone have the same experiences/ and or a solution to this issue??

Modbreak:

Changed the topic title because 1.5.3 is no new update. 

bvdbos

"the upgrade" ? Which is your firmware? Or Fibaro? 1.5.3 has been out since nov 1st... If you want to re-add devices you have to make sure you resetted them (look in the manual) or maybe it's enough to send an exclude-command from Homey.

FB2906

Thanks bvdbos for your comment. I have done most of that, but without succes. I'm not sure what you mean by the exclude command from homey Firmware version is 1.5.3, and Fibaro is version 1.5.17

lubbertkramer

FB2906 said:

After the upgrade from last night 24 feb. the Z-wave network is no longer working accordingly. Fibaro products are no longer responding. and after a re-start Homey doesn't even recognize the learning mode etc from fibaro products anymore. Does anyone have the same experiences/ and or a solution to this issue??

1.5.3 upgrade? If you take a look at firmware.athom.com you see 1.5.3 is no new update, so what did you do that broke your z-wave? Did you do a downgrade from 1.5.6 experimental because that will give you a non working z-wave chip

FB2906

Case Closed