›
This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.
Z-Wave

Z-wave broken after revert to stable channel from 1.5.6 experimental

mehdiomehdio Member
edited December 2017 in Questions & Help
Hi there,
Has anyone experiencing issue when reverting to stable channel ?
I was at version 1.5.6 on exp channel but decided to do a full factory reset to 1.5.3. But Z-wave is not working anymore at all.
Logs says (in the setting section) : 

Error: error_getting_version
Try restarting Homey.

I try to reboot, redo a full factory reset without success :neutral:. I basically went back to a stable channel that's is less stable than the experimental one? :disappointed:

Tagged:

Comments

  • casedacaseda Member
    edited December 2017
    @mehdio
    this is a known "issue" since the z-wave chip firmware was updated in 1.5.6+, as this can not be reverted with a Homey revert.
    you have 2 options currently:
    1. contact support@athom.com to send in your homey to let it get fixed over there (or at least ask for what to do next if you want to stay stable)
    2. go back to experimental until at least homey fw v1.5.6 is in stable, and then revert to stable.
  • mruitermruiter Member
    I would go back to experminental and wait for 1.5.6 to become stable. i guess it wont take that long anymore.
    1.5.3 was even worse then the current experimentals ;)
  • mehdiomehdio Member
    thx @caseda , @mruiter ; guys for your help ! I guess I'll wait to the stable update 1.5.6 :)
Sign In or Register to comment.