This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.

Always on !

I have a pond outside and want to ensure that in the event of a power failure, and after it is restored the pump, filter and heater unit come back on. The heater is only on a certain times of the year (when water temp gets cold), and there are other pumps (waterfall and aerator) that only operate at weekends, but need to come back on.

Is there an easy way to do this, either with a flow or an "always on" setting I have not discovered yet ?

Or is it just a flow that checks the units status every 5 or so minutes ?

Andrew

Comments

  • casedacaseda Member
    edited November 2017
    If you look at most zwave brands their wallplug, they either have the ability to remember the last state when a power failure occurs.
    And I think the same was for plugwise (zigbee)

    Or in case for fibaro and nodon, that have an always on setting (so even the button on the device is disabled, and the accidental switch in homey gui)
  • For plugwise this is the case...
Sign In or Register to comment.