›
This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.
Closed Solved

[Solved] Fibaro Motion Sensor not "resetting"

johannes1702johannes1702 Member
edited October 2017 in Archive
Hey, I'm desperately trying to get a Fibaro Motion Sensor running. It is quite close to Homey but once the motion triggers the sensor (short green light) it sets Motion Alarm to Yes in Homey and stays there. So any flow becomes useless as it is triggered only once. :-(
 I set Blindtime to 7 and Cancellation to 2 but no change. :-(

Any ideas?

Johannes
Tagged:

Comments

  • Fire69Fire69 Member
    Have you tried removing it from Homey and adding it again?
  • johannes1702johannes1702 Member
    Yes did this twice
  • casedacaseda Member
    @johannes1702
    What version of the app do you use?

    And can you look look into the zwave log (settings - > zwave - > stuff for geeks) if any data is coming in it all from the sensor for turning off the alarm.
  • johannes1702johannes1702 Member
    After adding and removing it a couple of times, it now works.

    Hint: Connect it by pressing the button 3 times. Wait until Homey says it conneted it successfully. Then press the button again 3 times to ensure all parameters have really transmitted. Not sure if it really solved the issue, but maybe it helps someone. :-)
This discussion has been closed.