This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Solved
When Pairing Z-Wave Devices, I Encountered All Sorts Of Errors
lesterchan
Member
My Z-Wave devices are pretty much standard, TKH Smart Energy Plug, Aeotec Smart Switch 6, Fibaro Motion Sensor, Aeotec Motion Sensor.
I keep having problems pairing devices after like paring 20 devices. Here are my paired devices
It is so frustrating. Not sure if I unpair and pair everything too fast in a go.
I keep having problems pairing devices after like paring 20 devices. Here are my paired devices
- 1x MCO Touch Panel 1 Gang
- 1x MCO Touch Panel 4 Gang
- 11x Aeotec Smart Switch 6
- 4x TKB Smart Meter Switch
- 3x Aeotec Motion Sensor
- 3x Fibaro Window Sensor
- 1x Fibaro Motion Sensor
- Could not reach the device anymore
- Cannot find Z-Wave device
- vdevice.drivers.zwavebasic.pair.senddata_timeout
- vdevice.drivers.zwavebasic.pair.Operation canceled
- vdevice.drivers.zwavebasic.pair.ALREADY_ACTIVE
It is so frustrating. Not sure if I unpair and pair everything too fast in a go.
Tagged:
Comments
Best,
Stefan
I might reset to factory settings tonight and try again, starting with MCO Touch Panel.
@addwindtan: The log ID is 80B4F97B01
Once I went around unpairing, I factory reset Homey and it works now!
Thanks for the feedback and good to hear that your issue has been solved!
A good thing to learn out of this is that Z-wave congestion can also be caused by devices that were never part of Homey’s network... and that it is essential to unpair device’s not in use / formally belonging to another (crashed / replaced) controller...
enjoy your Homey!