This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
WALLC-S / Qubino ZMNHDD1 association does not work
I have a WALLC-S controller configured as two buttonpairs with both single/double click enabled.
In Homey I made associations with 4 devices for each combination (2 pairs x single or double click = 4)
This works great for 3 devices, but is does not work for the 4th, a Qubino flush-dimmer ZMNHDD1.
This device does not react to commands from the WALLC-S controller at all.
Seemingly commands are being sent, because the WALLC-S' red led lights up shortly and it stays responsive afterwards.
But nothing happens on the dimmer.
The Qubino dimmer works fine when operated with connected switch or through Homey
Has anyone else experienced this issue? Any solution?
In Homey I made associations with 4 devices for each combination (2 pairs x single or double click = 4)
This works great for 3 devices, but is does not work for the 4th, a Qubino flush-dimmer ZMNHDD1.
This device does not react to commands from the WALLC-S controller at all.
Seemingly commands are being sent, because the WALLC-S' red led lights up shortly and it stays responsive afterwards.
But nothing happens on the dimmer.
The Qubino dimmer works fine when operated with connected switch or through Homey
Has anyone else experienced this issue? Any solution?