This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Fail to add zwave switch
I try to add zwave switches to homey but fail below are the steps I did please enlighten me if I did something wrong
1)setting---- remove a device ---- device successfully removed
2) device ----ground floor-----add a device
then it says something is wrong
1)setting---- remove a device ---- device successfully removed
2) device ----ground floor-----add a device
then it says something is wrong
Comments
Without you putting a little effort in it we can't help. I lost my psychic capability when I turned 40
Below is my athom zwave log :
[2017-02-25T07:08:22.816Z] command status: removeNode, status: REMOVE_NODE_STATUS_LEARN_READY
[2017-02-25T07:08:29.767Z] command status: removeNode, status: REMOVE_NODE_STATUS_NODE_FOUND
[2017-02-25T07:08:30.747Z] command status: removeNode, status: REMOVE_NODE_STATUS_REMOVING_SLAVE
[2017-02-25T07:08:30.752Z] command status: removeNode, status: REMOVE_NODE_STATUS_DONE
[2017-02-25T07:08:30.759Z] Command end: removeNode
[2017-02-25T07:08:46.144Z] Command start: getNetworkTopology
[2017-02-25T07:08:46.325Z] Command end: getNetworkTopology
[2017-02-25T07:09:28.857Z] Command start: addNode
[2017-02-25T07:09:28.896Z] command status: addNode, status: ADD_NODE_STATUS_LEARN_READY
[2017-02-25T07:09:35.749Z] command status: addNode, status: ADD_NODE_STATUS_NODE_FOUND
[2017-02-25T07:09:38.959Z] command status: addNode, status: ADD_NODE_STATUS_FAILED
[2017-02-25T07:09:38.960Z] ProcessAddNode[16]: Error: ADD_NODE_STATUS_FAILED
[2017-02-25T07:09:38.967Z] Command end: addNode
[2017-02-25T07:09:53.414Z] Command start: addNodeAbort
[2017-02-25T07:09:53.422Z] Command end: addNodeAbort
[2017-02-25T07:10:05.396Z] Command start: getNetworkTopology
[2017-02-25T07:10:05.396Z] Command start: getNetworkTopology
[2017-02-25T07:10:05.451Z] Command end: getNetworkTopology
Also, when a pairing fails, I often remove the device from Homey AND reset it to factory defaults. It should be overkill, but who knows if it makes a difference.
Or did you do the 'remove a device' just to make sure the switch was properly reset?