This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Closed
Homey v1.0.1
This discussion has been closed.
Comments
But this mornig his led-ring was red.
I tried a PTP.
Then I tried to reset, but without any luck.
I can get a dark orange ring, a purple moving ring en a red ring. I tried to wait 1 second, 5 seconds, 30 seconds etc after a PTP to put it upside down. I still can't get him in recovery mode.
Someone any tips?
So: PTP, wait like 3 minutes, put the plug back in and after like 10-15 seconds hold him upsidedown.
No guarantees but u can try.
He only responds to a upsidedown the first seconds (turning dark orange or purple), but still no recovery-mode possible.
Turning it upsidedown after 10-30 seconds he just gives a RROD after a while.
Unplugging it did the trick though.
@stamplus Ledring turning dark orange or purple, should be a good thing. Orange means rebooting and Purple means updating... The updating can take a few minutes though...
If you plug it in and turn it upside down too soon, it goes into recovery (from which it will never leave, because you have to recover it from a computer then.
So plug it in, what 10-15 seconds and only THEN turn it upside down if you want to run the setup again.
If you're trying to fix a red ring, unplugging and plugging it again might solve it.
If it doesn't solve it, something might have gotten corrupted. You'll need to contact support for that (or do a full reset unfortunately...)
I can only click on "ok" .
Please help
Or reboot and then try again
No luck yet. Same error.
Always the weirdest malfunctions.
A reboot from Homey will not work anymore in that case, you will need to PTP (Pull The Plug). When Homey has restarted you should be able to install the new firmware.
Somebody having the same problem?
It took several weeks before my voice was understand well.
Homey did recognize exactly what I said. That's not the problem.
You can't control individual lights by voice, only all lights in a zone, or all lights at once.
So since Homey doesn't recognize 'eettafel' as a zone, he just turned on all the lights for you.
Als no response from athom yet.
Strange to leave support for the weekend, while you have a retail product launch.
Firmware releases werd most of the time on fridayafternoon without support during the weekend.
Wil leafe Homey in stores for a coupel of updates...
You could create zones, but that just complicates things ever more (IMO)