Aeotec older 4-in-1 sensor support

sossienl

Hi all,

I have 2 older 4-in-1 devices from Aeotec (Aeon labs), that didn't work correctly out of the box, using the Aeotec App.
But with the correct settings, you can make it work!

• Connect the device via the App, using the Multisensor 6 option.
• Once added, go to the settings of the device
• Add the following under "Raw configuration parameters" section
• 111,4,30;112,4,30;113,4,30;101,4,225
  

Now I have this device powered via USB, if you're using batteries you probably want to set "30" to a higher value, as it stands for the reporting interval per sensor. More info here: http://www.vesternet.com/resources/application-notes/apnt-31#.WBdM_-ErJGU

caseda

Little Side Note:
this won't be needed anymore when my PR is accepted by athom for the DSB05 (Multi Sensor 4-in-1)

Sandeman

 

sossienl said:

Hi all,

I have 2 older 4-in-1 devices from Aeotec (Aeon labs), that didn't work correctly out of the box, using the Aeotec App.
But with the correct settings, you can make it work!

• Connect the device via the App, using the Multisensor 6 option.
• Once added, go to the settings of the device
• Add the following under "Raw configuration parameters" section
• 111,4,30;112,4,30;113,4,30;101,4,225
  

Now I have this device powered via USB, if you're using batteries you probably want to set "30" to a higher value, as it stands for the reporting interval per sensor. More info here: http://www.vesternet.com/resources/application-notes/apnt-31#.WBdM_-ErJGU

Thanks, this would be nice to use until the PR from caseda is accepted.
The problem is: the save button at the 4in1 sensor setting tab is disabled.  

caseda

@Sandeman ;;
look at the association groups and/or the wake-up time settings, it's probably on 0 somewhere there, which disables the button

when you find the issue, please iterate, then i can fix it still in the PR.

Sandeman

caseda said:

@Sandeman ;;;
look at the association groups and/or the wake-up time settings, it's probably on 0 somewhere there, which disables the button

when you find the issue, please iterate, then i can fix it still in the PR.

I changed all values but the save button keeps disabled.
Tried to enable the button in chrome browser but no luck to save the changed settings.

association groups and wake-up time are both >0

caseda

@Sandeman ;
can you post a screenshot of your settings? if there is a scrollbar then please multiple screenshots so all settings are in view

Sandeman

Wake-up time is 0, by changing it to 1 the save button isn't enabled.
Hope this can help you.

caseda

@Sandeman ;
oh men, so many mistakes in this older version of the app.

change these settings:
"on-time" = 300
"enable motion sensor" = Disabled
"Which reports to send. Interval group 1" = 225
"Unsolicitate reports interval for timing groups 1" = 240
"Unsolicitate reports interval for timing groups 2" = 720
"Unsolicitate reports interval for timing groups 3" = 720

wake-up interval = 7200

then you should be able to save, if not, change these settings as well:
"Which reports to send. Interval group 2" = 1
"Which reports to send. Interval group 3" = 1

Save

After save:
switch back these settings:
"on-time" = 240
"enable motion sensor" = Enabled

then save again.

Sandeman

fixed!

Thanks.