›
This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.
Closed

Using Fibaro Motion Sensor as PIR for Light Switch

viktorviktor Member
in Archive
Hi all, maybe someone can help me with the right parameters to set a PIR for a Lamp.
I used one Motion Sensor non plus associated with Node 87 (Fibaro Relay Switch) to make a PIR Sensor for my House Entry. Relay set to auto off after 1200ms.
My problem is that after the 20sek. the light is gone and not starting new or lighting if the motion is still active.
Tried to set motion blind time and cancellation delay lower, but no success.

Can someone help me with the right parameters?

Tnx

Comments

  • casedacaseda Member
    you shouldn't need the auto off for the relay, the motion sensor will send an on (when detecting motion) and an off (when no motion for the amount of (cancellation) seconds specified) signal.
    the motion sensor does not send signals every time the motion is actived within the cancellation time, so the timer inside the relay will not reset.
This discussion has been closed.