This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Comments
Nattelip for President !
works, Thx !
Btw did notice Homey triggered my voice testrule 3 times in 1 go when i pressed B1 ON.
Could be it's the panel itself sending the command 3 times just to ensure command always reaches a X10 unit ( in this case Homey), will play with test flow and see if i can catch the burst so Homey runs command only once. For now all works well, have a really nice gadget and can trigger light on/off.
note sure if allowed to show this link, but here they have the MARMITEK/HAIBRAIN Easytouchpanel at sale in NL for 79,- eur
https://www.pahedomotica.nl/product/easytouch-panel10-10inch-touchscreen-x10-rf/
ok thx, good to know, have all working perfect now.
No major issue with the re-runs, made a flow where i catch the re-runs by adding a Better-Logic Boolean X10RUN which is by default OFF, flow is only allowed to run in that state, when flow starts first time it flips to ON, then executes Homey command and with a delay of 2 sec Boolean is set to OFF again.
During these 2 seonds any re-run command will not execute anything since Boolean is still set to ON. No problem for me if there's a 2 sec waiting time between any new X10 command, have a great remote. Have listed sample below.