This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Closed
Homey v0.8.35
This discussion has been closed.
Comments
were the flows you moved above or below the folder you moved them to (assuming you moved them to a folder here)
i don't mean where you created them, but where they ended up after creation, above or below the flows you moved
Ha. Found it finaly. I must say it's not the easiest way of moving.
did you fix this ?
i have the same problem, re adding them isnt working, also tried to re-install the app, power down and reboot didnt work
I cannot reset my homey. When powering up with the homey upside down, I get an orange ring for a 2 seconds and then it goes to red for 3 seconds, after that again purple..
It doesn't make a difference if I hold it upside down for 1, 2 ,5 10, 30 seconds.
please advice
Only Hue Phoenix lamps do not work. Other Hue lamps work.
Note though:
Do not turn off your wall plugs.
Homey will not receive the change in kw/h and Wattage which results in an error and not being able to turn it on again afterwards (except for manual, then the error will "fix" itself with a few seconds)
Already put a github issue about it.
I'm having problems with having a flow folder name save correctly, anyone experiencing the same?
https://github.com/athombv/homey/issues/634
@JanH did you do a reset and a full wipe after the upgrade to 0.8.35?
@JanH thanks, you not having done a reset shows that it works immediatly after the update.
Maybe there are others that did a reset and a full wipe that can comment on their findings when trying to reproduce.
Edit, I experience the same after saving a flow in a folder, it gets 'kicked' out for me to. There's an issue for that on Github: https://github.com/athombv/homey/issues/632
They are only send to the motion sensor after it has woken up, after you changed the parameters.
So you need to wait until it reaches it's wake up time (default 7200 seconds/2 hours) or wake it up manually by trippel clicking the B-Button.
I've been able to send settings to my Aeotec MultiSensor 6, but it looks like you still have to press the Action Button on the sensor before the settings are saved to it, it does not save settings to it when the sensor wakes up on its own
Someone with connection problems here? My Homey is unreachable over my.athom and over ip. Only after power disconnection i can access the first site with menu. After that is over.
Thx
Did you reset and wipe your homey?