This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Closed
Unable to add a Fibaro Motion Sensor
Anyone else having problems? I am unable to add a new Fibaro Motion Sensor I've just purchased, im on the experimental firmware.
"Het Z-Wave apparaat kon niet geanalyseerd worden. Het apparaat is toegevoegd als standaard apparaat met aan/uit functionaliteit."
Tried a couple times, nothing changes.
"Het Z-Wave apparaat kon niet geanalyseerd worden. Het apparaat is toegevoegd als standaard apparaat met aan/uit functionaliteit."
Tried a couple times, nothing changes.
This discussion has been closed.
Comments
the only thing i dont understand is the wake up interval and the polling interval.
Is the wake up interval (every 2 hours) a "hey homey i am still here, here are all the sensor values, im gone sleeping again"
and the polling time can be changed to x seconds which will make homey poll this device every x seconds?
It is not recommended to put the wake up interval under half an hour (1800 sec.) though.
And I don't think the Polling does anything with battery devices because the sensor is asleep.
I have a flow that turns on my lights as soon as the luminance is at a certain point, which interval's would be the best for this?
With the polling Homey does, will it retrieve the luminance value as well? So setting that to 3 or 5 minutes would be a good option?
you shouldn't use polling for luminance. Please do a little reading on the forum, if you searched for polling it would have led you there...