›
This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.

Can't adjust the LED ring brightness

MG11MG11 Member
edited April 2016 in Questions & Help
Hello guys.
If I try to change LED ring brightness under Homey Settings - no adjustments between 1% - 99% are possible.
I can only turn the light off (0%) or have the full brightness. Is it normal? 

Comments

  • BumblezBumblez Member
    edited April 2016
    What firmware version are you on? I believe there was a bug in an earlier version, that should be solved in the latest experimental version (0.8.30)

  • RocodamelsheRocodamelshe Member
    I am on 0.8.29 and can adjust between 0 and 100 so no problems here.
  • JPeJPe Member
    edited April 2016
    Try a value lower than 10, its not reacting on values above +/- 10 (I also have 0.8.29)
    even a value of 1 is already rather bright!!
  • MG11MG11 Member
    edited April 2016
    I have 0.8.29 and no difference between 1% - 99%. Same brightness level. 
    PS: OK, I can see some minor brightness changes at 1%-4%. But the light is still very bright.
  • DaneeDeKruyffDaneeDeKruyff Member

    Well, I can tell you it's still very bright on 0.8.30

    https://forum.athom.com/discussion/1160/led-ring-brightness-0-8-30#latest

  • MarcoFMarcoF Member
    edited April 2016
    I'm also running 0.8.29(Thanx @Fire69) and I dimmed the LED-ring.
    And the difference between 100 and 10 is really big!
  • casedacaseda Member
    The LEDring brightness did affect the responsiveness to my speech.

    It became less able to understand what I said (more gibberish), as if the brightness is linked with the microphone(s)

    I don't however know if it still was in 8.29 or 8.30 already.
Sign In or Register to comment.