›
This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.
Closed

Cannot interview Z-Wave dimmer

MichaelMichael Member
in Archive
I'm trying to add my wall mounted Z-Wave dimmers. It gets included, however it then starts interviewing the device. This fails with the error: "Your Z-Wave device could not be interviewed. The device has been added as a basic device".
When I try to do something with the device I get the error: "Error: Busy with another task".

My Homey was 1cm away from the device during inclusion and interviewing.
I've created a log as well: BFB741CB1C

This is the device: http://www.pepper1.net/zwavedb/device/33

Comments

  • luccie_007luccie_007 Member
    edited April 2016
    I have the same problem.

    Homey Firmware Version: 0.8.30

    Although it adds the dimmer after removing en retrying a few times.
    Then in the Insights i also get a Dim level.
    But at the device it is added as a generic, so no slider available.
    I can control it to go on and off. But cannot set the dim level.

    I haven't checked if i change the dim level on the device it self if it gets another value in the Insights.

    Anyone knows if there is a Git issue already? I couldn't find one in a quick search.
    https://github.com/athombv/homey/issues/426



This discussion has been closed.