This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
MbenzNo
About
- Username
- MbenzNo
- Joined
- Visits
- 598
- Last Active
- Roles
- Member
Comments
-
I now see that it is only my Qubino dimmers that have these options. One of my Qubino dimmers in my living room is not identified as a light dimmer. I guess I have to re-install it again to identify the load as a light. I am actually using a Qubino…
-
It seems that it is not possible to show more than 10 Zones in the app. I have 12 Zones Pluss Home and I am unable to reach the last two Zones in the app. Samsung Galaxy Note 4, Android v. 6.0.1 App v. 2.3.3 - Build 69 Homey firmware v. 1.2.2 Homey…
-
Hi! Is there any plan to include PAT02-B multisensor (Temp/Humidity) ? What information, and how to get it, is needed to include this in the app? http://products.z-wavealliance.org/ProductManual/File?folder=&filename=Manuals/1186/PAT02_Manual.p…
-
Hey! Did anyone succeed in making an app for Id Lock? I am no programmer myself, and would like to se an app for this lock.
-
My Homey would not boot powered from different USB power adapters, included the provided one. It was during fault investigation that I discovered that it would boot with a different USB lead from my computer USB port. I was hoping it was possible wi…
-
And Yet another update... Homey left idling for more than 2,5 hours, still connected to USB on computer. Then Installed Sonos app. Homey Freezes immediately and goes offline when "OK Homey" command is spoken. Then it reboot after a couple of minute…
-
Yet another update… 10 minutes later it Works again connected to my computer With the short lead! I now managed to do a full factory reset. If I use the original USB cable and Power supply, it only light up one white LED on one side. Us…
-
New update: Logged in to my homey (still Connected to my computer With a short USB lead). Reset Z-Wave network. Then I intended to do a full reset. Turned Homey Upside Down and the reset procedure began. After inputting the key for my…
-
Done some more testing... Power down for more than 15 minutes, reconnect and let alone for more than an hour. Steady white light to one side from connecting power. No contact. Tried another shorter thinner USB cable without ferrite beads, original…
-
Already done, but hoping for quicker response from the community ;-)