›
This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.

The Homey Community has been moved to https://community.athom.com.

This forum is now read-only for archive purposes.
Closed

KAKU Wall Switch not compatible?

PimVolkertPimVolkert Member
in Archive
To replace an older X10 wall switch I just bought a KAKU wall switch (AWST-8800). Homey does not react to this mono switch when I try to install it. Any ideas?

Earlier today I was not able to reinstall the KAKU contact sensor which I installed a day ago. Also no reaction from Homey. Same problem?

Comments

  • bvdbosbvdbos Member
    The Rfxcom chip probably got disabled. Powering down (unplugging for a few seconds) helps....
  • PimVolkertPimVolkert Member
    Thanks @BasVanDenBosch , that worked for all (ehh most) of the transmitters. Next challenge: Create a flow with which I can turn a (zwave) light off using the KAKU switch.
This discussion has been closed.