Fibaro dimmer 2 with 2 way switch (wisselschakeling)

Comments

• mruiter Member

  March 2017

  Did you Google? 
  
  https://www.robbshop.nl/over-z-wave/z-wave-projecten/z-wave-hotelschakeling
  
  First hit the best
• dott Member

  March 2017

  Yes I did, and yes I read this. This seems also based on the Dimmer one version if you look at the connectors. Hence my question, there is a lot about the version 1 but not on version 2.
• mruiter Member

  March 2017

  There not that different.. Just the layout of the wireinputs differs.
  Still a L N Sx S1 S2 and the O(utput) (Thats the Sinus with Arrow in it in some drawings)
• htilburgs Member

  March 2017

  I had the same issue, solved it and documented it. See:
  
  http://www.tilburgs.com/wordpress/domotica/z-wave-en-de-razberry/domoticz-fibaro-dimmer-2/
  
  I'll hope you'll succeed with this manual (dutch). 
  Regards, Harm
• phil_s Member

  March 2017

  @htilburgs thanks for sharing! 
• dott Member

  March 2017

  Thank you Harm and mruiter! I will continue with my own domotica and hope to learn a lot here.
• htilburgs Member

  March 2017

  No thanks and I hope you've a lot of fun (as I do)!! 
• Veldkornet Member

  September 2017 edited September 2017

  I have a similar question, I think.
  
  So at the moment, I have mine installed with 2 wires as shown in @htilburgs diagram here.
  
  From Homey everything works great. My question is around the actual switch on the wall.
  
  Currently, if I turn if "on". It turns on (or dims up to full anyway).
  But if I want to turn it off, I need to move the switch to off, then back to on, but even then it dims to 1% and doesn't switch off.
  
  how can I make the switch function just like a normal on off switch?
  
  
  
  Actually, I figured it out a minute after this. 
  
  Schakelaar type: tuimelschakelaar
  hotelshakeling: on

  Capture.PNG 53.7K
• Jeroenvano Member

  August 2018

  Hi all,
  
  I would like to install a 2 way switch setup as illustrated below, but would like to use double toggle switches (supposed to single below) to have the ability on both switches to activate scenes.
  
  Is this possible and if so how would this need to be wired on S2?
  
  
  
  Thanks!
  
  
• Sytze Member

  August 2018

  Did you check the link a few posts up?
  https://forum.athom.com/discussion/comment/47860/#Comment_47860 
  
• Jeroenvano Member

  August 2018

  Sytze said:

  Did you check the link a few posts up?
  https://forum.athom.com/discussion/comment/47860/#Comment_47860 
  

  Yes seen that, but that is also using toggle switches with one button (whipper) and I would like to have toggle switches with 2 buttons on each of them for scene activation. 
  
• Makkelijk Unconfirmed, Member

  August 2018 edited August 2018

  Jeroenvano said:
  
  

  Is this possible and if so how would this need to be wired on S2?
  

  In this scheme you basically wire both switches parallel, so if you want to use S2 on both switches you need to do the same. This means that you need to pull an extra wire from the main switch to the second switch.