This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Closed
Homey 1.5.8 and 1.5.9
This discussion has been closed.
Comments
I'm asking because a few months ago I created a flow to start a radio with IR. It worked fine. I got busy with work and when I used the flow again, this week, no response from the radio. Was the range reduced?
I tried to change the position by rotating it a little and test the flow, but that didn't solve it.
This one works, at sunset check if qubino is off, if yes, then turn on.
This one does not work, at 23.00 check if qubino is on, yes? then turn off
Do I do something wrong? Is the 23.00 not an every day trigger?
I create an alarm and a flow to speak the time. It's now 20:45 but the alarm must be set at 18:45 that's GMT without summertime, and I am in CET+summertime (Europe/Amsterdam).
If I look into Homey Logger for example the convert the UTC time to my local time, in the System overview I see the UTC time.
This means that sunset/sunrise probably is also 2 hours off? Or just the time trigger flow card?
Sunset at 21:04 still 15 minutes to go, probably it will be ok
And sunset is right on time, no offset in time.
Found it: https://firmware.athom.com/
Seems stable. It has not caused problems in z-wave / zigbee for me. I still like to see these protocols improved, though!