This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Solved Z-Wave
Pending Z-wave commands
![renzor](https://secure.gravatar.com/avatar/c9a3ff5471835bfb4422d1714b5bea56/?default=https%3A%2F%2Fvanillicon.com%2Fc9a3ff5471835bfb4422d1714b5bea56_50.png&rating=g&size=50)
Hello there!
I've got a device which wakes up once every 30 minutes. When I change a value of this device, ofcourse, it will only be picked up after the device wakes up. In my script, I would like to read the value that I've set up even before it's updated on the device. So to keep my question short, is there a way to read out the command queue of Z-wave devices in my script?
Many thanks![;) ;)](https://forum.athom.com/resources/emoji/wink.png)
Kr.
I've got a device which wakes up once every 30 minutes. When I change a value of this device, ofcourse, it will only be picked up after the device wakes up. In my script, I would like to read the value that I've set up even before it's updated on the device. So to keep my question short, is there a way to read out the command queue of Z-wave devices in my script?
Many thanks
![;) ;)](https://forum.athom.com/resources/emoji/wink.png)
Kr.
Comments
So do you want another app, than the one setting the value, to read this out?
Because if it is the same app, can't you make the driver write the same value that you use for setting the device into a variable?
It was in the developer tools for a very short amount of time, but they removed from the page again (within a day, before it even worked), not sure why.
Probably with a good reason