This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Disable built-in speech commands
MVanHouts
Member
Is there a way to disable the built-in speech commands? I would really like to be able use the built-in keywords in my flows. Now it gives a warning message when I want to use a built-in keyword and the flow does not operate.
In my specific case I want to use the keyword 'TV on' to first set on the power for my entire home cinema set, then turn on the TV, after that my home cinema receiver and dim the lights.
I find it quite annoying if I have to use a different keyword just because there is a built-in command set.
Regards, Marco
In my specific case I want to use the keyword 'TV on' to first set on the power for my entire home cinema set, then turn on the TV, after that my home cinema receiver and dim the lights.
I find it quite annoying if I have to use a different keyword just because there is a built-in command set.
Regards, Marco
Comments
Not sure what you are using to control the TV tho, but it might be possible to create a flow that used the device card for your tv. (if it has the class tv tho, so the new IR apps for example)
So then you should be possible to: IF TV is turned on -> THEN switch on homecinema etc. this way you can still use the built-in command AND trigger other stuff. But only works when your TV is added as a TV class. And has the needed device trigger card.
"Homey version 1.3.2 will resolve this by disabling the error feedback "I could not find any devices to turn on/off" when flows have been triggered as well."